alpha rail warp body question

[maddboy32]

will an "alpha" rail hold a warp ule body with no mod.?

i don't have one on me right now and i can't remember if it was cut down low enough or not. anybody????

[BigEvil]

Good question;

PAGING TUNA....

[Practice Target]

Nope! I own one and it had to be machined. See Below.

http://www.jayloo.com/files/pics/28000/Red_Mag_3_rs.jpg

[guseppe16]

Along this same thought: Are there any rails that don't need milled to accept warp bodies?

[Cyberave68]

Along this same thought: Are there any rails that don't need milled to accept warp bodies?

Not that i know of....

[IronHyde]

No common rails, but there is one that I saw a pic of on a guys mag with a ripper body I believe. It had little droplets of water milled into the side. Ill see if I cant find a pic

[Practice Target]

No common rails, but there is one that I saw a pic of on a guys mag with a ripper body I believe. It had little droplets of water milled into the side. Ill see if I cant find a pic
That would be a Benchmark rail, Not sure if that would clear either though.

[punkncat]

I had an Alpha V1 and did not have to mill it to fit. It did put two very small dimples in the top edge of the rail, but not even enough to notice.

[maddboy32]

Nope! I own one and it had to be machined. See Below.

http://www.jayloo.com/files/pics/28000/Red_Mag_3_rs.jpg

sweet pic. thats about what i needed to see.

[maddboy32]

Not that i know of....

where the heck have you been?

[IronHyde]

That would be a Benchmark rail, Not sure if that would clear either though.


actually its not the benchmark rail, its looks to have been a custom job by someone and i think did 3 designs. i sold one version to p8ntball4m3 a while back and the other i saw on someones mag. I havent found it yet, ill try